Zoeken
Zoeken kan via de modus 'eenvoudig zoeken' (één veld) of uitgebreid via 'geavanceerd zoeken' (meerdere velden). Zo kan je bv. zoeken op een combinatie van een auteursnaam (auteur), een jaartal (jaar) en een documenttype.
Boekenmand
Nuttige resultaten kan je aanvinken en toevoegen aan een mandje. De inhoud hiervan kan je exporteren of afdrukken (naar bv. PDF).
RSS
Op de hoogte blijven van nieuw toegevoegde publicaties binnen uw interessegebied? Dit kan door een RSS-feed (?) te maken van jouw zoekopdracht.
nieuwe zoekopdracht
Problems of the gonad index and what can be done: analysis of the purple sea urchin Strongylocentrotus purpuratus
Ebert, T.A.; Hernández, J.C.; Russell, M.P. (2011). Problems of the gonad index and what can be done: analysis of the purple sea urchin Strongylocentrotus purpuratus. Mar. Biol. (Berl.) 158(1): 47-58. http://dx.doi.org/10.1007/s00227-010-1541-2
In: Marine Biology: International Journal on Life in Oceans and Coastal Waters. Springer: Heidelberg; Berlin. ISSN 0025-3162; e-ISSN 1432-1793
|  |
| Auteurs | | Top |
- Ebert, T.A.
- Hernández, J.C.
- Russell, M.P.
|
|
|
| Abstract |
The gonad index, GI, is widely used as a measure of changes in reproductive state. There are, however, problems with its use because it is based on the implicit assumption of an isometric relationship between gonad size and some measure of total size. If, for example, gonad weight and total weight are used, the exponent for an allometric relationship usually is ignored and hence assumed to be 1.0. It is further assumed that this exponent is fixed for all states of the reproductive cycle and that gonads begin to develop at size = 0. Data for the purple sea urchin Strongylocentrotus purpuratus at Gregory Point, Oregon, USA, gathered over a period of 31 months showed that these assumptions cannot be supported. The relationship is better modeled with a function that (1) takes into account size of initial gonad production and (2) allows allometric exponents that vary with site or season. Thus, a better approach is to use a wide range of sizes to estimate size when gonads begin to develop and then, with this correction, ANCOVA to test for differences of gonad size among samples. Gonad changes at Gregory Point were estimated using fixed sizes of 5 cm diameter and 60 g total weight. Publishing means for X and Y, the standard error of the estimate, R 2, and slope for each regression are shown to be sufficient to compare our results with results across studies. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
