Zoeken
Zoeken kan via de modus 'eenvoudig zoeken' (één veld) of uitgebreid via 'geavanceerd zoeken' (meerdere velden). Zo kan je bv. zoeken op een combinatie van een auteursnaam (auteur), een jaartal (jaar) en een documenttype.
Boekenmand
Nuttige resultaten kan je aanvinken en toevoegen aan een mandje. De inhoud hiervan kan je exporteren of afdrukken (naar bv. PDF).
RSS
Op de hoogte blijven van nieuw toegevoegde publicaties binnen uw interessegebied? Dit kan door een RSS-feed (?) te maken van jouw zoekopdracht.
nieuwe zoekopdracht
Mitigating unaccounted fishing mortality from gillnets and traps
In: Fish and Fisheries. Blackwell Science: Oxford. ISSN 1467-2960; e-ISSN 1467-2979
|  |
| Trefwoorden |
|
| Author keywords |
discards; entanglement gears; entrapment gears |
| Auteurs | | Top |
- Uhlmann, S.S.
- Broadhurst, M.K.
|
|
|
| Abstract |
Gillnets and traps often are considered to have fewer holistic environmental impacts than active fishing gears. However, in addition to the targeted catches, gillnets and traps still cause unwanted mortalities due to (i) discarding, (ii) ghost fishing of derelict gear, (iii) depredation, (iv) escaping or dropping out of gear, (v) habitat damage, and potentially (vi) avoiding gear and predation and (vii) infection of injuries sustained from most of the above. Population‐level concerns associated with such ‘unaccounted fishing mortalities’ from gillnets and traps have been sufficient to warrant numerous attempts at mitigation. In this article, we reviewed relevant research efforts, locating 130 studies in the primary literature that concomitantly quantified mortalities and their resolution through technical modifications, with the division of effort indicating ongoing concerns. Most studies (85) have focused on discard mortality, followed by ghost‐fishing (24), depredation (10) and escape (8) mortalities. The remaining components have been poorly studied (3). All problematic mortality components are affected by key biological (e.g. species), technical (e.g. fishing mechanisms) and/or environmental (e.g. temperature) factors. We propose that these key factors should be considered as part of a strategy to reduce impacts of these gears by first assessing modifications within and then beyond conventional configurations, followed by changes to operational and handling practices. Justification for this three‐tiered approach is based not only on the potential for cumulative reduction benefits, but also on the likely ease of adoption, legislation and compliance. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
