Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
Uncertainty of excess density and settling velocity of mud flocs derived from in situ measurements
Fettweis, M. (2008). Uncertainty of excess density and settling velocity of mud flocs derived from in situ measurements, in: Particles in Europe workshop, October 13-14, Bologna, Italy.
In: (2008). Particles in Europe workshop, October 13-14, Bologna, Italy. [S.n.]: Bologna, Italy. , meer
Is gerelateerd aan:Fettweis, M. (2008). Uncertainty of excess density and settling velocity of mud flocs derived from in situ measurements. Est., Coast. and Shelf Sci. 78(2): 426-436. dx.doi.org/10.1016/j.ecss.2008.01.007, meer
|
| Trefwoorden |
In situ measurements
Properties > Physical properties > Density
Separation > Chemical precipitation > Flocculation
Velocity > Settling rate
ANE, Noordzee [Marine Regions]
Marien/Kust |
| Author keywords |
settling velocity; floc density; error propagation; floes; North Sea |
| Project | Top | Auteur |
- Quantification of Erosion and Sedimentation patterns to Trace the natural versus anthropogenic sediment dynamics, meer
|
| Abstract |
Direct or indirect measurements of excess density and settling velocity are inherently associated with uncertainties (errors) due to a lack of accuracy of the measuring instruments, inadequate precision of the observations, and the statistical nature of the variables (floc size, primary particle size and primary particle density). When using observations, some understanding of the uncertainties is needed. Based on the theory of error propagation, we have estimated the error of the excess density and the settling velocity of mud flocs using the measurement data of OBS, SPM filtration, LISST 100C, CTD and Sedigraph. The measurements were carried out between 2003 and 2005 in the southern North Sea in the course of eight tidal cycles. The excess density was calculated based on fractal description of mud flocs and using floc and water density data. The water density was derived from CTD measurements and the floc density was calculated using SPM concentration, particle volume concentration, and water and primary particle densities. The settling velocities of flocs were calculated on the basis of their fractal structure following Winterwerp, J. [1998. A simple model for turbulence induced flocculation of cohesive sediments. Journal of Hydraulic Research 36, 309-326]. The results show that the relative standard deviations for excess density, fractal dimension and settling velocity are about 10%, 2.5% and 100%, respectively. These uncertainties should be regarded as lower limits of the real error because the errors due to inaccuracies of the OBS, LISST and Sedigraph have been excluded, as they are unknown. From the results it was found that the statistical error of excess density was dominated by uncertainties of SPM concentration and primary particle density, and for fall velocity by uncertainties of primary particle and floc sizes, respectively. These statistical uncertainties will always be high when dealing with natural flocs or particles and cannot be reduced by increasing the accuracy of the instruments. They should therefore be taken into account when modelling cohesive sediment transport, either by using the calculated standard deviations for settling velocity, or by introducing a floc size (settling velocity) distribution in the transport model. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
