Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
Sandbox models of relay ramp structure and evolution
Hus, R.; Acocella, V.; Funiciello, R.; De Batist, M. (2005). Sandbox models of relay ramp structure and evolution. J. Struct. Geol. 27(3): 459-473. dx.doi.org/10.1016/j.jsg.2004.09.004
In: Journal of structural geology. PERGAMON-ELSEVIER SCIENCE LTD: Oxford. ISSN 0191-8141; e-ISSN 1873-1201, meer
|  |
| Trefwoord |
|
| Author keywords |
Sandbox models; Relay ramps; Normal fault systems; Fault linkage; Fault interaction |
| Auteurs | | Top |
- Hus, R.
- Acocella, V.
- Funiciello, R.
- De Batist, M., meer
|
|
|
| Abstract |
Relay ramps are a common feature formed during the growth of normal fault systems. We performed analogue experiments to investigate the structure and evolution of relay ramps. An extending rubber sheet induces extension at the base of a sand pack (brittle crust analogue). Silicone bars between the rubber and the sand control the location of fault nucleation. We tested the role of fault spacing, fault length, overlap length and fault strike in the evolution of relay ramps. The modelled relay ramps evolved in three stages, characterized by the growth of the normal faults, their interaction and linkage. Interaction and linkage occurred only when the combined length of the two interacting faults was larger than eight times their spacing. The length to width ratio of the relay ramps during the interaction stage showed preferred geometries, clustering around three. The propagation of the fault tips was observed both before and after the linkage stage. Overlap length and spacing relations of the modelled relay ramps are similar to those in nature, at different scales, and can be explained using existing mechanical models. Nevertheless, the further propagation of the fault tips after linkage has not been described previously. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
