Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
On the minimum required sampling frequency for reliable fatigue lifetime estimation in structural health monitoring. How much is enough?
D'Antuono, P.; Weijtjens, W.; Devriendt, C. (2023). On the minimum required sampling frequency for reliable fatigue lifetime estimation in structural health monitoring. How much is enough?, in: Rizzo, P. et al. European Workshop on Structural Health Monitoring. EWSHM 2022 - Volume 1. pp. 133-142. https://dx.doi.org/10.1007/978-3-031-07254-3_14
In: Rizzo, P.; Milazzo, A. (Ed.) (2023). European Workshop on Structural Health Monitoring. EWSHM 2022 - Volume 1. Springer: Cham. ISBN 978-3-031-07253-6; e-ISBN 978-3-031-07254-3. XXI, 930 pp. https://dx.doi.org/10.1007/978-3-031-07254-3, meer
|
| Beschikbaar in | Auteurs |
|
Documenttype: Congresbijdrage
|
| Trefwoord |
|
| Author keywords |
Lifetime assessment; Offshore wind turbine foundations; Samplingfrequency; Signal analysis; Stress life fatigue |
| Abstract |
Structural Health Monitoring (SHM) represents the course of action of implementing a damage assessment strategy for engineering infrastructures. SHM systems can provide substantial aid towards the improvement of Offshore Wind turbines (OWTs) reliability, sustainability, and profitability. Usually, SHM system development is affected by three major concerns: the sensing technology, the associated signal analysis, and the interpretation algorithm. In this work, we focus on the relevance of the signal analysis on fatigue, being one of the most relevant damage sources. At some stage of the signal analysis process, analogue signals from strain transducers shall go digitized for computer analysis. In this phase, the engineer pursues the trade-off between gathering all the necessary information and storing the minimum data quantity. The sampling frequency adopted is paramount to this aim and can have substantial effects on the final lifetime estimated by damage accumulation rules. The Nyquist-Shannon sampling theorem is not well suited for minimum sampling frequency estimation in OWTs SHM. It allows recovering the frequency content of the original signal (bandwidth limited) yet does not guarantee correct reconstruction of its amplitudes (quantisation error). On top of that, the quantisation error is always on the non-conservative side of the lifetime estimation. We, therefore, provide examples showing that a ratio of the signal maximum "significant frequency" to the sampling frequency greater than or equal to ten (as opposed to two in the Nyquist-Shannon sampling theorem) is the rule of thumb to follow to avoid lifetime underestimation. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
