Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
Experimental deformation analysis of an adhesively bonded multi-material joint for marine applications
Jaiswal, P.R.; Kumar, R.I.; Juwet, T.; Luyckx, G.; Verhaeghe, C.; De Waele, W. (2023). Experimental deformation analysis of an adhesively bonded multi-material joint for marine applications. Strain 59(2): e12433. https://dx.doi.org/10.1111/str.12433
In: Strain. British Society for Strain Measurement: Swansea. ISSN 0039-2103; e-ISSN 1475-1305, meer
|  |
| Trefwoord |
|
| Author keywords |
digital image correlation; fibre-optic sensor; MMA; multi-material joint; strain |
| Auteurs | | Top |
- Jaiswal, P.R., meer
- Kumar, R.I., meer
- Juwet, T.
|
- Luyckx, G.
- Verhaeghe, C.
- De Waele, W., meer
|
|
| Abstract |
The strength and deformation of full-scale adhesively bonded multi-material joints is studied in this paper. Four joints with a thick layer of methyl methacrylate adhesive (MMA) have been manufactured in shipyard conditions. In two specimens, cracks have been introduced at steel–adhesive and composite–adhesive interfaces. One cracked and one un-cracked specimen were subjected to quasi-static tensile testing; the two remaining specimens were stepwise loaded/unloaded with increasing load until failure. The strain in the adhesive layers was measured with digital image correlation (DIC). This showed a predominant shear deformation and dissimilar shear strain patterns for different bond lines. Fibre Bragg (FBG) sensors were used to monitor strains at steel and composite constituents and to detect the onset and evolution of damage in the un-cracked specimen. Strains measured by FBG sensors correspond well with DIC results at nearby regions. All specimens failed by delamination of the composite panel near the composite–adhesive interface. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
