Open WL Archief (OWA)

Over het archief

Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.

Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.

Basisinformatie over ‘Open Access to scholarly information'.

[ meld een fout in dit record ]

mandje (1): toevoegen | toon

---

one publication added to basket [348391]

SIMMAN 2020: subreport 2. Computation of open‐water propeller characteristics Van Hoydonck, W.; Eloot, K.; Delefortrie, G.; Mostaert, F. (2020). SIMMAN 2020: subreport 2. Computation of open‐water propeller characteristics. Version 2.0. FHR reports, 17_001_2. Flanders Hydraulics Research: Antwerp. VIII, 25 + 22 p. app. pp. https://dx.doi.org/10.48607/59 Deel van: FHR reports. Flanders Hydraulics Research: Antwerp, meer

---

Beschikbaar in	Auteurs
Waterbouwkundig Laboratorium: Open Repository 370472 [ download pdf ]
Documenttype: Projectrapport

---

Trefwoorden

Computational fluid dynamics Harbours and waterways > Manoeuvring behaviour > Open water Numerical calculations Open water Propellers

Author keywords

CFD

---

Auteurs		Top
Van Hoydonck, W., meer Eloot, K., meer Delefortrie, G., meer Mostaert, F., meer

---

Abstract

The objective of this report is to investigate the possibility of determining open‐water propeller characteristics using Computational Fluid Dynamics (CFD). The propeller used in the current investigation is the four‐bladed propeller as used for the benchmark KRISO Very Large Crude Carrier 2 (KVLCC2) hull. The computed open‐water characteristics are not part of the CFD submission of Flanders Hydraulics Research (FHR) for Workshop on Verification and Validation of Ship Manoeuvring Simulation Methods (SIMMAN). Computations are executed according to the specifications of the International Towing Tank Conference (ITTC), where the angular velocity of the propeller remains constant and results are computed for a range of advance ratios ? by altering the forward velocity of the propeller. This contrasts with the recommendations of NUMECA for open‐water computations, where the forward velocity is held constant, and the advance ratio is changed by altering the angular velocity of the propeller. Computations are executed in a rotating frame of reference which allows for larger time steps than in a fixed frame of reference. The by NUMECA recommended time step values were however not strict enough for low values of the advance ratio: the smallest value used is 1/8 of the recommended value. A comparison between the numerical results and the reference values shows a good agreement. This type of computation could be used in the future as an alternative to experimentally determined open‐water propeller characteristics if a solution is found for the slow convergence at ? = 0.

---

Alle informatie in het Integrated Marine Information System (IMIS) valt onder het VLIZ Privacy beleid

Top | Auteurs

IMIS is ontwikkeld en wordt gehost door het VLIZ.