Over het archief
Het OWA, het open archief van het Waterbouwkundig Laboratorium heeft tot doel alle vrij toegankelijke onderzoeksresultaten van dit instituut in digitale vorm aan te bieden. Op die manier wil het de zichtbaarheid, verspreiding en gebruik van deze onderzoeksresultaten, alsook de wetenschappelijke communicatie maximaal bevorderen.
Dit archief wordt uitgebouwd en beheerd volgens de principes van de Open Access Movement, en het daaruit ontstane Open Archives Initiative.
Basisinformatie over ‘Open Access to scholarly information'.
| one publication added to basket [8522] |
Wave run-up and overtopping: prototype versus scale models
De Rouck, J.; Verdonck, R.; Troch, P.; Van Damme, L.; Schlütter, F.; De Ronde, J. (1998). Wave run-up and overtopping: prototype versus scale models, in: Edge, B.L. (1999). Coastal Engineering 1998 conference proceedings June 22-26 1998 Copenhagen, Denmark. pp. 1039-1052
In: Edge, B.L. (1999). Coastal Engineering 1998 conference proceedings June 22-26 1998 Copenhagen, Denmark. Coastal Engineering Research Council of the American Society of Civil Engineers: USA. ISBN 0-784-0411-9. 3699 pp., meer
|
| Beschikbaar in | Auteurs |
|
Documenttype: Congresbijdrage
|
| Auteurs | | Top |
- De Rouck, J., meer
- Verdonck, R.
- Troch, P., meer
|
- Van Damme, L., meer
- Schlütter, F., redacteur
- De Ronde, J., meer
|
|
| Abstract |
The determination of the crest level is one of the most important points in the design of sloping coastal structures. The crest level of sloping coastal structures is governed by wave run-up and overtopping. Recent measurement results of run-up on prototype have indicated that wave run-up may be underpredicted by scale model tests. So full scale measurements of wave run-up is necessary. At the same time the overtopping discharge on a prototype breakwater will be measured. Within the MAST III - OPTICREST project, these measurements will be carried out at coastal structures at two locations: Zeebrugge (Belgium) and Petten (The Netherlands). The results obtained from these prototype measurements will be compared with those from scale model tests and will be used to calibrate numerical models. This paper also presents the contents of the OPTICREST project. |
IMIS is ontwikkeld en wordt gehost door het VLIZ.
